OPERATING INSTRUCTIONS 1. Remove the cover and the nozzle. 2. Fill the water tank with a minimum of 50 ml (1.7 oz.) to a maximum 150 ml (5 oz.) of water (see maximum waterfill line). 3. Add 3 to 5 drops of your favorite essential oil to the water and replace the nozzle first and then the cover. 4. Dry hands and plug the power supply into the side of unit. Plug the adaptor into a standard household outlet. 5. Push the middle button to turn the unit “ON”. • The unit will turn “ON” on CONTINUOUS mode, with the fan on High. • If the button is pressed a SECOND time, the fan will run on the LOW setting. • If pressed a 3rd time the unit will shut off. 6. Preferred TIME setting button is on the right. • The unit will turn “ON” on CONTINUOUS mode. • Press Timer Button once for 1 hour run time. • Press twice for 2 hour run time. 7. The LED lights turn “ON” with the unit. Use Light Button to turn lights “ON” or “OFF”. 8. The unit will automatically stop once the water reaches the Minimum Water Level.
SAFETY INSTRUCTIONS • Follow the operating instructions. • Do not use another adapter to operate the unit. • DO NOT OVERFILL THE WATER TANK. Overfilling with water may cause damage to the unit. The maximum water level is 1,3 cm (0.5 inch) below the nozzle or 150 ml (5 oz.). • Plug-in the power supply only after filling the unit with water. • Keep the unit on a flat and secure surface at all times. • If moving the unit, ensure you unplug the unit from the power supply. • Turn the power off when not in use. • Do not operate the unit with wet hands. • Do not immerse the unit in water. • Should a problem arise, unplug the unit. Do not attempt to open the unit. The unit must be serviced by a qualified technician. Return to the store or retailer where you bought the unit. • KEEP AWAY FROM CHILDREN AND PETS. CLEANING INSTRUCTIONS • Clean the unit with a soft cotton cloth after each use. • Do not use any cleaning agent. This will keep the unit in good working order and
CLEANING INSTRUCTIONS • Clean the unit with a soft cotton cloth after each use. • Do not use any cleaning agent. This will keep the unit in good working order and maximize the atomizing rate. • DO NOT WASH IN A DISHWASHER.
TROUBLESHOOTING When switched “ON” the unit does not operate. Check that: • the power supply is securely plugged into the socket at the unit. • the plug is securely plugged into a wall socket. • there is water in the tank and the water level is correct. The unit is equipped with a safety feature which sometimes needs to be reset. Follow these steps to reset the unit. 1. Unplug and empty the unit. 2. Plug-in and unplug the unit 3 times (wait 1 minute between each time you plug-in the unit). 3. Fill the unit with water, plug-in and turn on. The unit should have reset itself and should start normally.
No dispersal or lower than usual. Check: • for correct water level after removing the nozzle and cover. • that the transducer is clean, if not, clean it. • that nozzle and cover are placed securely.